
Round Rock Water Filtration, Tested First and Installed Right
We test your water, then recommend and install the right new system: whole-home filtration, a softener, a salt-free conditioner or reverse osmosis. We work in Round Rock, Brushy Creek and Georgetown.
- Free in-home water test
- New system quoted by phone
- Free installation
- Every part named in your quote
Water Treatment Services for Your Home
Most water problems trace back to a few causes: hardness minerals, disinfectant taste, dissolved solids, iron or sulfur, and equipment that has worn out or was never set up right. We start with water testing and analysis, then match the fix to the reading. That might be whole-home filtration with carbon media, a water softener or salt-free water conditioner for scale, or a reverse osmosis system under the kitchen sink for drinking water. We also handle iron and sulfur removal and UV water purification when a test points that way.

Whole-Home Filtration
Point-of-entry carbon filtration that treats every tap in your home, with free installation.

Salt-Free Water Conditioners
Scale protection for your pipes, water heater and fixtures that uses no salt, no brine and no drain line, sized after a free water test.
Water Testing & Analysis
We measure hardness, chlorine, dissolved solids, pH and iron at your tap, then tell you which new system fits your home.
Water Softener Installation
New softeners sized from your measured hardness, installed with free installation.
Reverse Osmosis Systems
Under-sink RO installs, including a 5-stage tank RO and a tankless RO, sized to your tested water.
Well Water Filtration
Filtration for private wells chosen from a lab-style test.
Iron and Sulfur Removal
We trace orange stains and rotten-egg odor to their source, then install a properly sized oxidizing filter.
UV Water Purification
Chemical-free UV-C disinfection for your home's water, sized to your peak flow.

About Our Company
Water Filtration Round Rock tests, services and installs water treatment equipment in homes across Williamson County and the surrounding area. Hard water is common here, and so are softeners and filters that were sold, set to the wrong hardness and then left alone for years. A lot of what we do is getting that equipment working again.
We would rather swap a set of valve seals than a whole system when the seals are the problem. When the tank is cracked, the resin is spent or the parts are no longer made, we say that plainly and show you why. Either way, you hear the cause first and the price second.
How a Visit Runs
From the first call to the startup flush, here is what happens and what you can expect at each step.
- 1
You tell us what you are noticing
Spots on shower glass, a chlorine smell, crusty faucet aerators or a softener that quit regenerating. Describe what you see, and we pick a visit time that works around your day for the free water test.
- 2
We test your water at the tap
We check hardness, total dissolved solids, chlorine and pH, and look at your plumbing and where the system will go. You see each reading as we take it.
- 3
You get the right new system
We explain what the readings mean and quote the new system the test supports, with free installation, by phone or in person.
- 4
Install day
We shut off the main, cut in at your loop or main line, add a bypass and connect the drain with an air gap. Water is off only while we are tying in.
- 5
Startup and settings
We flush new media to drain, program the regeneration schedule to your hardness and household size, and retest the water so you can see the difference. Then we show you how to bypass the system and where the filters are.
How We Choose the Right System for Your Home
Every home's water is different, so we test it first and match the new system to the readings. We explain the reasoning behind every recommendation.
We find the cause, not just the symptom
Spots, scale or a chlorine smell can come from hardness, disinfectant, dissolved solids or iron. Each one calls for different equipment at a very different cost. We test the water at your tap so the cause is clear before we recommend a system.
We tell you when an old unit should be replaced
A cracked mineral tank, resin that iron or chlorine has broken down, or a control valve with discontinued parts means the old unit is done. When that is the case, we show you the readings and recommend the new system that fits your water.
Test results drive the recommendation
We size equipment from what the water test shows: hardness in grains per gallon, total dissolved solids, chlorine and pH. A test that shows moderate hardness may point to a salt-free conditioner instead of a softener, and we will say so.
Installs built for easy upkeep
We plumb in a bypass valve, leave unions at the connections and set the system where you can reach the salt lid and filter housings. That keeps cartridge changes and salt top-ups simple for you.
Your floors and fixtures protected
We lay down drop cloths, catch the water that drains from opened lines and flush the system to a drain, not your sink. When we leave, the work area is wiped down and old cartridges or media are bagged and taken with us.
What Sets the Price of a Water Treatment System
Neighbors on one street can need very different equipment, so we only price after the free water test. A few things set the total. Every new system we install includes free installation, and the quote lists each piece of equipment and each extra part separately.
Once the free water test is done, we go over the options by phone or in person: the new system your test supports, every line named. We give no dollar figures until we have seen your water and your setup.
- What the readings show
- Very hard water needs a bigger resin bed and more regeneration capacity. A heavy chlorine or chloramine taste may call for catalytic carbon in place of standard carbon. Iron or sulfur means another stage.
- Home size and water demand
- Your bathroom count and household size set the flow the system must keep pace with. A tank that is too small lowers shower pressure and regenerates too often.
- Where the system connects
- Some houses were built with softener inlet and outlet pipes already roughed in near the water heater. When those are missing or hard to reach, we run new pipe to a usable spot, which adds material and time.
- Access to a drain and outlet
- Softeners and RO units need a drain with a correct air gap, and most control valves need power. How far away both are changes the materials.
- The system you choose
- New equipment is priced by tank size, valve type and media. Installation is free, and every part is listed in your quote.
Questions We Hear Often
Does Round Rock water need a softener?
Central Texas water often holds enough calcium and magnesium to scale fixtures and the inside of water heaters, but the amount changes from supply to supply. A reading in grains per gallon shows whether a softener pays off, whether a salt-free conditioner will do, or whether neither is needed. So we test before we suggest any equipment.
Can you replace a softener that quit working?
Yes. We test your water, size a new softener to your hardness and household, and install it in place of the old unit with free installation. If your readings point to a salt-free conditioner instead, we tell you that.
What does the free test measure?
We read hardness, total dissolved solids, chlorine and pH at your faucet and look for iron signs like orange staining. We also inspect any equipment already in place. You watch each reading come in, and we explain what it means for your pipes and your drinking water.
How does a softener differ from a salt-free conditioner?
A softener's resin trades hardness minerals for sodium, so the water truly turns soft, and it needs salt and a drain. A salt-free conditioner's media changes how the minerals act so they are less apt to stick as scale, yet they remain in the water. With no salt and no drain, it works well in some homes where hardness is moderate.
Is reverse osmosis still worth it with whole-home filtration?
Sometimes not. Whole-home carbon removes chlorine taste and odor at every faucet. An under-sink reverse osmosis system takes kitchen drinking and cooking water further, forcing it through a membrane that lowers total dissolved solids. If your test shows high dissolved solids or you want more confidence in what you drink, RO deserves a look.
What warranty does a new system carry?
We warrant the systems we install: lifetime warranty on tanks and ceramic discs, 5 years on the control valve, circuit board and filter media, and 1 year on labor. We tell you which pieces of it cover the exact system you are looking at.
Is the installation actually free?
It is, on every new system. Your quote includes the equipment plus any extra plumbing parts your house calls for, like a new loop or drain line, each on its own line so you can see what you pay for.
How disruptive is installation day?
The water stays off only while we connect to the line. We protect the floor, catch draining water, flush the new system to a drain and tidy up on the way out. Your taps are running again before we load the truck.
Where We Work
We are based in Round Rock, TX, and test and install water treatment systems throughout the city. We also serve Brushy Creek, Georgetown, Hutto, Pflugerville, Cedar Park and Leander, along with Wells Branch, Manor, Santa Rita Ranch and Steiner Ranch. Water supply and hardness can vary from one utility to the next, which is one more reason we test at your tap ahead of suggesting anything.
- Round Rock
- Brushy Creek
- Wells Branch
- Cedar Park
- Pflugerville
- Hutto
- Georgetown
- Leander
- Manor
- Santa Rita Ranch
- Steiner Ranch
If you are near any of these communities and not sure whether we come out to you, ask when you call to set up your free water test.
Find Out Which System Your Water Needs
Start with a free water test at your home. We will check the readings and tell you which new system fits your water and your household, with free installation.